Modern Receiver Front-Ends : Systems, Circuits, and Integration

個数:

Modern Receiver Front-Ends : Systems, Circuits, and Integration

  • 提携先の海外書籍取次会社に在庫がございます。通常3週間で発送いたします。
    重要ご説明事項
    1. 納期遅延や、ご入手不能となる場合が若干ございます。
    2. 複数冊ご注文の場合、分割発送となる場合がございます。
    3. 美品のご指定は承りかねます。
  • 【入荷遅延について】
    世界情勢の影響により、海外からお取り寄せとなる洋書・洋古書の入荷が、表示している標準的な納期よりも遅延する場合がございます。
    おそれいりますが、あらかじめご了承くださいますようお願い申し上げます。
  • ◆画像の表紙や帯等は実物とは異なる場合があります。
  • ◆ウェブストアでの洋書販売価格は、弊社店舗等での販売価格とは異なります。
    また、洋書販売価格は、ご注文確定時点での日本円価格となります。
    ご注文確定後に、同じ洋書の販売価格が変動しても、それは反映されません。
  • 製本 Hardcover:ハードカバー版/ページ数 400 p.
  • 言語 ENG
  • 商品コード 9780471225911
  • DDC分類 621.38418

Full Description

Architectures BABAK MATINPOUR and JOY LASKAR
* Describes the actual implementation of receiver architectures from the initial design to an IC-based product
* Presents many tricks-of-the-trade not usually covered in textbooks
* Covers a range of practical issues including semiconductor technology selection, cost versus performance, yield, packaging, prototype development, testing, and analysis
* Discusses architectures that are employed in modern broadband wireless systems

Contents

Preface. Acknowledgments.

1 INTRODUCTION.

1.1 Current State of the Art.

2 RECEIVER SYSTEM DESIGN.

2.1 Frequency Planning.

2.1.1 Blockers.

2.1.2 Spurs and Desensing.

2.1.3 Transmitter Leakage.

2.1.4 LO Leakage and Interference.

2.1.5 Image.

2.1.6 Half IF.

2.2 Link Budget Analysis.

2.2.1 Linearity.

2.2.2 Noise.

2.2.3 Signal-to-Noise Ratio.

2.2.4 Receiver Gain.

2.3 Propagation Effects.

2.3.1 Path Loss.

2.3.2 Multipath and Fading.

2.3.3 Equalization.

2.3.4 Diversity.

2.3.5 Coding.

2.4 Interface Planning.

2.5 Conclusion.

3 REVIEW OF RECEIVER ARCHITECTURES.

3.1 Heterodyne Receivers.

3.2 Image Reject Receivers.

3.2.1 Hartley Architecture.

3.2.2 Weaver Architecture.

3.3 Zero IF Receivers.

3.4 Low IF Receivers.

3.5 I ssues in Direct Conversion Receivers.

3.5.1 Noise.

3.5.2 LO Leakage and Radiation.

3.5.3 Phase and Amplitude Imbalance.

3.5.4 DC Offset.

3.5.5 Intermodulations.

3.6 Architecture Comparison and Trade-off.

3.7 Conclusion.

4 SILICON-BASED RECEIVER DESIGN.

4.1 Receiver Architecture and Design.

4.1.1 System Description and Calculations.

4.1.2 Basics of OFDM.

4.1.3 System Architectures.

4.1.4 System Calculations.

4.2 Circuit Design.

4.2.1 SiGe BiCMOS Process Technology.

4.2.2 LNA.

4.2.3 Mixer.

4.2.4 Frequency Divider.

4.3 Receiver Design Steps.

4.3.1 Design and Integration of Building Blocks.

4.3.2 DC Conditions.

4.3.3 Scattering Parameters.

4.3.4 Small-Signal Performance.

4.3.5 Transient Performance.

4.3.6 Noise Performance.

4.3.7 Linearity Performance.

4.3.8 Parasitic Effects.

4.3.9 Process Variation.

4.3.10 50-Ω and Non-50-Ω Receivers.

4.4 Layout Considerations.

4.5 Characterization of Receiver Front-Ends.

4.5.1 DC Test.

4.5.2 Functionality Test.

4.5.3 S-Parameter Test.

4.5.4 Conversion Gain Test.

4.5.5 Linearity Test.

4.5.6 Noise Figure Test.

4.5.7 I/Q Imbalance.

4.5.8 DC Offset.

4.6 Measurement Results and Discussions.

4.6.1 Close Examination of Noise Figure and I/Q Imbalance.

4.6.2 Comments on I/Q Imbalance.

4.7 Conclusion.

5 SUBHARMONIC RECEIVER DESIGNS.

5.1 Illustration of Subharmonic Techniques.

5.2 Mixing Using Antisymmetric I-V Characteristics.

5.3 Impact of Mismatch Effects.

5.4 DC Offset Cancellation Mechanisms.

5.4.1 Intrinsic DC Offset Cancellation.

5.4.2 Extrinsic DC Offset Cancellation.

5.5 Experimental Verification of DC Offset.

5.6 Waveform Shaping Before Mixing.

5.6.1 Theory and Analysis.

5.6.2 Experimental Verification on GaAs MESFET APDP.

5.6.3 Implementation in Silicon.

5.7 Design Steps for APDP-Based Receivers.

5.8 Architectural Illustration.

5.9 Fully Monolithic Receiver Design Using Passive APDP Cores.

5.9.1 Integrated Direct Conversion Receiver MMIC's.

5.9.2 Receiver Blocks.

5.9.3 Additional Receiver Blocks.

5.10 Reconfigurable Multiband Subharmonic Front-Ends.

5.11 Conclusion.

6 ACTIVE SUBHARMONIC RECEIVER DESIGNS.

6.1 Stacking of Switching Cores.

6.1.1 Description and Principles.

6.1.2 Subharmonic Receiver Architecture.

6.2 Parallel Transistor Stacks.

6.2.1 Active Mixer.

6.2.2 Receiver Architecture.

6.2.3 Extension to Passive Mixers.

6.3 Extension to Higher-Order LO Subharmonics.

6.4 Multiple Phase Signal Generation from Oscillators.

6.5 Future Direction and Conclusion.

7 DESIGN AND INTEGRATION OF PASSIVE COMPONENTS.

7.1 System on Package (SoP).

7.1.1 Multilayer Bandpass Filter.

7.1.2 Multilayer Balun Structure.

7.1.3 Module-Integrable Antennaw.

7.1.4 Fully Integrated SoP Module.

7.2 On-Chip Inductors.

7.2.1 Inductor Modeling.

7.2.2 Inductor Parameters.

7.2.3 Application in Circuits.

7.3 Capacitors.

7.4 Differentially Driven Inductors.

7.5 Transformers.

7.5.1 Electrical Parameters.

7.5.2 Physical Construction.

7.5.3 Electrical Models.

7.5.4 Frequency Response of Transformers.

7.5.5 Step-Up/Step-Down Transformers and Circuit Applications.

7.6 On-Chip Filters.

7.6.1 Filters Using Bond Wires.

7.6.2 Active Filters.

7.7 On-Wafer Antennas.

7.8 Wafer-Level Packaging.

7.9 Conclusion.

8 DESIGN FOR INTEGRATION.

8.1 System Design Considerations.

8.1.1 I/O Counts.

8.1.2 Cross-Talk.

8.1.3 Digital Circuitry Noise.

8.2 IC Floor Plan.

8.2.1 Signal Flow and Substrate Coupling.

8.2.2 Grounding.

8.2.3 Isolation.

8.3 Packaging Considerations.

8.3.1 Package Modeling.

8.3.2 Bonding Limitation.

8.4 Conclusion.

9 FUTURE TRENDS.

9.1 CMOS Cellphones.

9.2 Multiband, Multimode Wireless Solutions.

9.3 60 GHz Subsystems in Silicon!

9.4 Interchip Communications.

9.5 Ultrawideband Communication Technology.

9.6 Diversity Techniques.

9.7 Conclusion.

Index.